WCP GreyT User Manual page 24

GreyT Telescope - User Guide
(Rev 1)
Gearbox - Step 9
Bolt the two halves of the gearbox together. The bolt locations for the different Gearbox
configurations are shown on the following four pages.
When the Gearbox is fully assembled, make sure the Drum Flanges do not rub against
the Gearbox Plates when the Output Shaft is spun by hand.
Note: Unless otherwise specified, the bolt locations are the same across both the
Non-Flipped and Flipped configurations.
Table of Contents Page 24
wcproducts.com