Advertisement
GreyT Telescope - User Guide
(Rev 1)
Gearbox - Step 3
The 1/2" ID x 1-1/8" OD Flanged Bearing will be a light press fit and may be pressed in
by hand or with an arbor press. The image below shows the side the bearing must be
installed from for all configurations of the Telescope Gearbox.
The Nutstrips used to mount the GreyT Telescope must be cut to 1-1/2" long and
assembled in the orientation shown in the image below.
Note: The Nutstrips are an optional way of mounting the GreyT Telescope� If you plan
on mounting the Telescope differently or are assembling the Gearbox in the Flipped
configuration, you may omit the Nutstrips and associated Bolts from this step.
Table of Contents
Page 18
wcproducts.com
Advertisement
