WCP GreyT User Manual page 19

GreyT Telescope - User Guide
(Rev 1)
Gearbox - Step 4
The 1/2" ThunderHex ID x 1-1/8" OD Flanged Bearing will be a light press fit and may be
pressed in by hand or with an arbor press. The image below shows the side the bearing
must be installed from for all configurations of the Telescope Gearbox.
The Nutstrips used to mount the GreyT Telescope must be cut to 1-1/2" long and
assembled in the orientation shown in the image below.
Note: Just like in the previous step, the Nutstrips in this step are completely optional�
If you plan on using a different mouting method or are assembling the Gearbox in the
Flipped configuration, you may omit the Nutstrips and associated bolts from this step.
Table of Contents Page 19
wcproducts.com