Advertisement
GreyT Telescope - User Guide
(Rev 1)
Telescope - Step 6
Compress the assembled stages from the previous step by hand. Thread two #10-32 x
3/8"L bolts into the top two holes of the Top Block. These bolts will act as pins to keep
the Top Block in place.
The #10-32 x 1/2"L bolts will be threaded into the bottom two holes in the Top Block,
and will act as the hardstops for this stage. They will have to be installed with one 0.090"
thick #10 Washers.
Repeat this step for both sides of the Top Block.
Note: Do not overtighten the #10-32 x 1/2"L bolts� This may crush the 3D printed
spacers and cause the bolts to rub�
Note: If any of the bolts used in this step rub against the smaller tube while it is
moving, add 0�010" thick #10 Washers (WCP-0038) underneath them until they no
longer rub�
Table of Contents
Page 38
wcproducts.com
Advertisement
