How To Use In Manual Operation; Making A New Program - Duplo Programatic Mark - II Operation Manual

How to use in Manual Operation:

Turn on the power to the cutter, wait until the backgauge moves back and will
recalibrate the position and this display appears:
NOTE: There will be a cursor (❑) flashing over at the last number, this is the work area.
C: 26"125
1: 00"00❑
Manual mode has two operating controls:
1) The backgauge moves with the manual keys
2) If you press (0 - 9) entering 17000, the screen appears:
C: 26"125
1: 17"00❑
Press (RUN), the backgauge will move to the requested position.

Making a New Program:

Turn on the power to the cutter, wait until the backgauge moves back and will
recalibrate the position and this display appears:
NOTE: There will be a cursor (❑) flashing over at the last number, this is the work area.
C: 26"125
1: 00"00❑
Select a program number from 1-9, if you press (PROG) (1) this screen appears:
C: 26"125
1: 00"00❑
PROG: 1
2: 00"000
PROG: 1
2: 00"000
PROG: 1
2: 00"000
PROG: 1
2: 00"000
9
FAST SLOW FAST
FWD FWD REV
SLOW
REV