Operation Instructions; Basic Functions - Knoll k.stand User Manual

3 Operation Instructions

To ensure safe operation of the ECS+ control unit, please
observe the following safety instructions:
CAUTION—Risk of
injury and electric shock
Keep children away from electric height-adjustable desks,
control units and handset.
CAUTION—Risk of
pinching
When you change the desktop position (especially without
using pinch protection), you must ensure that no people or
objects are located in the hazardous area nor may reach
into it.
NOTICE
In case of a main power breakdown, or if the power
cord is unplugged during the movement of the drives,
a manual reset may be necessary! Please see section
3.2.
NOTICE
The control unit might be damaged by power surges.
Unplug the power cord during a thunderstorm or if you
do not intend to use the desk for a longer period.
©Knoll, Inc.

3.1 Basic functions

NOTICE
You must read the user manual carefully before installing
or operating the control unit.
If chosen handset doesn't fit to this user manual, please
see separate user manual for actual handset.
Overload protection!
If the total load on the equipment is too high you will only
be able to drive for 2 seconds. The system will then stop
and you need to take weight off the table. After some
weight is removed, adjust the table again.
Overheat protection!
If heavy loaded and driven continuously for a long period
of time the motor may overheat. The software registers
this and, if overheated, system will shut down and you
will have to wait 9 minutes before being using the table
again.
Anti-Collision "AC"!
The ECS+ is equipped with intelligent software for pinch
protection. If a collision is detected system will stop and
back off about 1 inch.
IMPORTANT! Make sure to remove the blocking item
causing the pinch before trying to operate the table again.
Failure to do so may cause injury to user or equipment.
k.stand Height-Adjustable Table Standard Electric and Extended Electric—Stroke 650/470 User Manual 10