Engine Oil: Filling Up - Audi R8 2015 Maintenance Manual

Audi R8 2015 ➤
Maintenance - Edition 03.2016
– Pull oil filter element -3- and O-ring -2- out of sealing cap -1-.
– Clean sealing surfaces of sealing cap -1-.
– Lightly lubricate new O-rings -2- and -4- with engine oil and
insert O-rings.
– Fit new oil filter element -3- in sealing cap -1-.
– Screw sealing cap -1- into oil filter housing and tighten it to
specified torque using socket (32 mm) (see table of tightening
torques for installation
Continue installation in reverse sequence.
3.58

Engine oil: filling up

Caution
Risk of engine damage if the engine is revved too soon after
changing the oil!
♦ The engine must only run at idling speed as long as the
oil pressure warning lamp in the instrument cluster is on.
♦ Increase the engine speed only after the warning lamp has
gone out.
Note
Refer to ELSA maintenance table for engine-specific oil grades.
10-cyl. petrol engine 5.2 ltr. FSI
3.58.1 10-cyl. petrol engine 5.2 ltr. FSI
Procedure:
– Fill 7.0 ltr. of engine oil into oil reservoir.
– Start engine and run at idling speed.
– After 30 seconds at idling speed, turn engine off.
– Add another 1.3 ltr. of engine oil into oil reservoir.
– Then check oil level and adjust if necessary
52
3. Maintenance
⇒ page 51 ).
⇒ page 52
⇒ page 53 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.