Audi R8 2015 Maintenance Manual page 26

Audi R8 2015 ➤
Maintenance - Edition 03.2016
Note
When using battery tester - VAS 6161- , ensure that the soft‐
♦
ware is up to date.
If if is not possible to measure the state of charge with battery
♦
tester - VAS 6161- , measure the battery's no load voltage
⇒ page 20 .
3.9.3 Measuring no load voltage of battery
Special tools and workshop equipment required
♦ Hand-held multimeter - V.A.G. 1526 C-
♦ Or: digital multimeter - V.A.G. 1715-
Requirements:
• Battery must not be placed under load from connected elec‐
trical equipment for at least 2 hours before test.
• Battery must not have been charged for at least 2 hours before
test.
• Engine must remain off for at least 2 hours before test.
• Ignition switched off during test.
Removal steps:
– Remove luggage compartment back panel trim ⇒ General
body repairs, interior; Rep. gr. 70 ; Luggage compartment trim
panels; Overview of fitting locations - luggage compartment
trim panels .
– Remove luggage compartment floor ⇒ General body repairs,
interior; Rep. gr. 70 ; Luggage compartment trim panels;
Overview of fitting locations - luggage compartment trim pan‐
els .
20
3. Maintenance
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.