Audi R8 2015 Maintenance Manual page 30

Audi R8 2015 ➤
Maintenance - Edition 03.2016
– Brake caliper (driver's side): Remove cap(s) -1- from bleeder
screw(s).
– Fit bleeder hose -1- attached to collector container onto bleed‐
er screw from inside of rim.
– Open bleeder screw and allow brake fluid to discharge. Refer
to table for correct quantity of brake fluid to discharge
⇒ page 22 .
– Close bleeder screw.
– If there are two bleeder screws on each brake caliper: Repeat
procedure with second bleeder screw.
– Refit cap on bleeder screw(s).
– Repeat procedure on passenger's side.
Rear axle:
– Brake caliper (driver's side): Remove cap(s) -1- from bleeder
screw(s).
– Take reversible ratchet and appropriate socket from tool set
for brake bleeding - VAS 6564- and fit together.
– Run bleeder hose -1- from inside of rim through reversible
ratchet -2- and socket -3- and fit onto bleeder screw.
– Open bleeder screw with ratchet -2- and allow brake fluid to
discharge. Refer to table for correct quantity of brake fluid to
discharge ⇒ page 22
– Close bleeder screw.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
24
3. Maintenance
.