Audi R8 2015 Maintenance Manual page 11

Procedure for removing:
– Unscrew bolts -arrows-.
– Unfasten spreader rivet -1-.
– Repeat procedure on opposite side of vehicle.
– Remove noise insulation -2-.
Procedure for installing:
Install in reverse sequence. Note tightening torques (see table of
tightening torques for installation
2.3.2 Noise insulation (rear)
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1783- , measuring range 2 to 10 Nm
Table of tightening torques for installation:
Component/fastener
Securing bolts for spoiler
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
Securing bolts for noise insulation 2.5
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Procedure for removing:
– Unscrew bolts -2-.
– Unfasten spreader rivet -1-.
– Detach spoiler -3-.
⇒ page 4 ).
[Nm]
10
Audi R8 2015 ➤
Maintenance - Edition 03.2016
5
2. Preparations