Battery - BMW S 1000R 2018 Rider's Manual

9
ATTENTION
Jump-starting with a voltage
162
higher than 12 V
Damage to the motorcycle's
electronics
The battery of the donor mo-
torcycle must have a voltage of
12 V.
Do not disconnect the battery
from the onboard electrical sys-
tem when jump-starting the
engine.
z
Remove rider's seat (
Allow engine on support mo-
torcycle to run while jump-
starting.
Begin by clamping one end of
the red jumper cable to the
positive terminal of the dis-
charged battery and clamping
the other end to the positive
terminal of the donor battery.
Then clamp one end of the
black jumper cable to the
donor battery's negative
terminal while connecting
the other end to discharged
battery's negative terminal.
Start engine of motorcycle with
discharged battery in usual
way; if engine does not start,
wait a few minutes before re-
peating attempt in order to pro-
tect starter motor and donor

battery.

Allow both engines to idle for a
few minutes before disconnect-
ing jumper cables.
63).
Disconnect jumper cable from
negative terminals first, then
disconnect second cable from
positive terminals.
Installing rider's seat (

Battery

Maintenance instructions
Correct upkeep, recharging and
storage will prolong the life of
the battery and are essential for
recognition of warranty claims.
Compliance with the points be-
low is important in order to maxi-
mize battery life:
Keep the surface of the battery
clean and dry.
Do not open the battery.
Do not top up with water.
Be sure to read and comply
with the instructions for charg-
ing the battery on the following
pages.
Do not turn the battery upside
64).
down.
ATTENTION
Discharging of the connected
battery by the vehicle elec-
tronics (e.g. clock)