Table of Contents
Advertisement
Insert wheel speed sensor in
bore and secure with screw 1.
Set brake caliper 1 on right
and install screws 2 with ap-
propriate torque.
Radial brake calipers on
the axle adapter
28 lb/ft (38 Nm)
Remove adhesive tape from
wheel rim.
Operate brake lever firmly sev-
eral times until the pressure
point can be felt.
Removing rear wheel
Raise motorcycle, preferably
with a BMW Motorrad rear-
wheel stand.
Mounting rear-wheel stand
(
134).
Support the rear wheel, e.g.,
with a wooden block, so that
it cannot fall down after the
quick-release axle is removed.
Press brake caliper 1 against
brake disk 2
Brake pistons are pressed
back.
Remove axle nut 1 with
washer.
9
147
z
Advertisement
Table of Contents
