Table of Contents
Advertisement
General instructions
9
The 'Maintenance' chapter de-
scribes work involving the check-
132
ing and replacement of wear
parts that can be performed with
a minimum of effort.
If special tightening torques are
to be taken into account for
assembly, these are listed. An
overview of all required tightening
torques is contained in the
chapter "Technical Data".
Information on additional main-
z
tenance and repair work is pro-
vided in the Repair Manual for
your vehicle on DVD, which you
can obtain from your authorized
BMW Motorrad retailer.
Special tools and thorough spe-
cialized knowledge are required
to carry out some of the work
described here. If you are in
doubt, consult an authorized
workshop, preferably your au-
thorized BMW Motorrad retailer.
Tool kit
1
Hook wrench
without Dynamic Damp-
ing Control (DDC)
Adjusting spring preload
at rear wheel (
2
Reversible screwdriver in-
sert
Phillips PH1 and Torx T25
Remove and install trim
panel components.
Remove rider's seat
(
63).
Replacing front and
rear turn indicator light
sources (
156).
3
Open-ended wrench
Wrench size: 17 mm
Mirror clamping
4
Open-ended wrench
Wrench size: 10/13
Removing battery
(
164).
with Dynamic Damping
Control (DDC)
Adjusting spring preload
at rear wheel (
5
Reversible screwdriver with
Phillips and straight blade
OE
without Dynamic Damp-
ing Control (DDC)
71).
Adjust compression
damping on front wheel
(
73).
without Dynamic Damp-
ing Control (DDC)
Rebound-stage damping
on front wheel (
OE
72).
OE
OE
74).
Advertisement
Table of Contents
