Elba ES60-310 XD Instructions For The Use page 12

FASTENING THE INSTALLATION BRACKETS
• Each cooker top is provided with an installation kit including brackets and screws for
fastening the top to fixture panels from 2 to 4 cm thick.
• Turn the cooker top upside down and fasten the brackets "F and R" to the appropriate
socket holes, without tightening the screws "B" for the moment.
• Make sure that the brackets are fastened as shown in the figures.
FASTENING THE COOKER TOP
• Spread the sealing material "D" out along the fixture hole, making sure that the
junctions overlap at the corners.
• Insert the cooker top into the hole and position it correctly.
• Adjust the position of the brackets "F and R"; tooth C of the tabs should go into the
hole. Tighten screws "B" to block the cooker top firmly in position.
• With a sharp cutter or trimmer knife trim the excess sealing material around the edge
of the cooker top. Take care not to damage the benchtop.
Rear side
D
R
R
Fig. 1.6
12
(figs. 1.4, 1.5, 1.6)
Fig. 1.4
C
B
F
(figs. 1.4, 1.5, 1.6)
Front side
C
R
Fig. 1.5
D
B
F
F