Table of Contents
Advertisement
Observe the seat belt warning
light and warning message
Fig. 182: Seat belt status display on multifunction display
A Seat belt status display for the left rear seat
B Seat belt status display for center rear seat
C Seat belt status display for the right rear seat
D Warning symbol: Driver's or passenger seat belt not
fastened
Front seats
When the ignition is switched on, a warning signal
sounds and the red warning symbol
strument cluster flashes for 6 seconds if the driver's
or passenger seat belt has not been fastened. The
red warning symbol on the instrument cluster stays
on after 6 seconds until the driver's seatbelt and, if
occupied, the passenger's seatbelt have been
fastened.
A warning message is also displayed in the instru-
ment cluster.
When the speed of the vehicle reaches approxi-
mately 15 mph (24 km/h), a warning signal also
sounds and the red warning symbol
strument cluster flashes if the driver's seat belt or
passenger seat belt, if occupied, is not fastened.
Rear seats
After switching on the ignition, a seat belt status
display for the rear seats appears on the instrument
cluster.
The seat belt display disappears approx. 60 seconds
after driving off (Fig. 182).
The green symbol
ting on this seat has fastened their seat belt.
The red warning symbol
sitting on this seat has not fastened their seat belt,
or no-one is sitting on this seat. When the speed of
the vehicle reaches approximately
15 mph (24 km/h), a warning signal also sounds and
the red warning symbol
flashes for approx. 60 seconds if the seat belt on a
seat is not fastened.
Adjusting seat belt
D on the in-
Fig. 183: Adjusting the belt height
The height of the belt outlets for the front seats can
be adjusted.
e Adjust the height of the belt outlet so that the
D in the in-
Fastening seat belt
indicates that the person sit-
indicates that the person
in the instrument cluster
Fig. 184: Fastening seat belt
1. Assume an appropriate sitting position.
2. Adjust the backrest so that the shoulder belt
3. Grasp the seat belt by the belt latch and pull it
4. Insert the belt latch into the appropriate seat-
5. Make sure that the seat belt is not trapped or
6. Check that the horizontal section of the belt al-
belt runs across the middle of your shoulder, not
against your neck.
a. Upward – push belt outlet upward.
b. Downward – press locking button A and
move belt outlet.
> Please see chapter "Seats" on page 249.
passes over the center of your shoulder and is
positioned on your upper body.
slowly and evenly over your chest and hip.
belt buckle on the inner side of the seat until it
locks with an audible click.
twisted and that it is not rubbing against sharp
edges.
ways fits snugly across your pelvis. Therefore,
Seat Belts
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
247
Advertisement
Table of Contents
