Hybrid Vehicle - Porsche Cayenne 2020 Owner's Manual

Hybrid Vehicle

Warning stickers
Hybrid system components are each labeled with
one of the two warning stickers (illustration below),
which warn against touching components and of
high voltage.
e Never remove, deface or render warning stickers
and warning signs illegible.
e Never remove covers of hybrid system compo-
nents that are labeled with the warning sticker.
Key to pictograms
Risk of electric shock
due to improper use.
Warning of dangerous
electrical voltage.
Danger!
Follow the instructions
on hybrid system
components and in the
Manual.
Hybrid operating modes
The parallel plug-in hybrid drive allows the vehicle to
run in the following hybrid operating modes:
– Driving powered by the electric machine.
– Driving powered by the combustion engine (the
combustion engine charges the high-voltage
battery in parallel via the electric machine).
– Driving powered by the electric machine and
combustion engine. The electric machine also
assists the combustion engine in powering the
vehicle (boost).
– Driving with recuperation (energy recovery): The
electric machine charges the high-voltage bat-
tery, e.g. during braking, when the vehicle is
overrunning with the combustion engine running
and automatically when driving downhill.
Operating conditions for running the vehicle
on electric power
Information
To prevent fuel from collecting in the engine oil, oc-
casionally drive longer distances with the combus-
tion engine running.
b b The high-voltage battery is sufficiently charged.
b b Minimum engine oil temperature approx.
32 °F (0 °C).
b b Temperature of the high-voltage battery is nei-
ther too high nor too low.
b b Temperature of the electric machine is not too
high.
b b Hood is closed.
A message appears on the instrument cluster if
these conditions have not been met.
Starting the vehicle
b b Vehicle plug not inserted in the vehicle charge
port.
1. Press the footbrake.
2. Press the P button on the selector lever or select
operating mode N.
3. Do not press the accelerator pedal.
4. Turn operating device briefly to ignition lock po-
sition 2.
READY appears on the instrument cluster.
You can drive off normally.
Information
If the vehicle plug is inserted in the vehicle charge
port when the vehicle is started, a message appears
on the instrument cluster.
e Pull the vehicle plug from the vehicle charge port
within approx. 20 seconds.
Reaction after leaving the vehicle
After leaving the vehicle after the engine has stop-
ped automatically (driver's seat belt unfastened,
driver's door open and brake pedal released), the
engine will not start automatically. Additionally, in
operating mode D, R or M:
– The electric parking brake is engaged.
– The transmission parking lock P is engaged.
The vehicle can still be moved with the driver's door
open and the driver's seat belt unfastened by re-
leasing the electric parking brake manually. In this
case, the parking brake remains released and the
selected transmission range is still engaged.
Automatic engine starting is enabled again if one of
the following conditions is detected within 30 sec-
onds of leaving the vehicle:
Hybrid Vehicle
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
135