Table of Contents
Advertisement
Porsche Active Suspension Management (PASM) with air suspension and leveling system
A
The rear of the vehicle is raised to its initial level
and the light indicator goes off.
B
C
Information
D
– No other leveling system processes are executed
when the drop frame function is active.
E
– If the light indicator between the two buttons A
F
and B is flashing continuously, the drop frame
function cannot be activated, e.g. if there is no
G
compressed air, if the battery voltage is too low
H
or if there is a fault in the leveling system.
I
J
Leveling system when towing a trailer
Low level is not available when towing a trailer. Ter-
K
rain level and High level can only be selected up to a
L
speed of 22 mph (35 km/h) when towing a trailer.
M
NOTICE
N
Adjusting the level when towing a trailer can exceed
O
the vehicle's rated tongue weight.
P
e Always check the tongue weight at Medium
Q
height.
R
Switching leveling system off
S
T
WARNING
U
V
The vehicle can slip off the jack. Parts of the body
may be pinched or crushed.
W
Before lifting the vehicle using a lifting platform or
X
jack:
e Set Medium height manually.
Y
e Switch leveling system off.
Z
214
The automatic leveling system must be switched off
when driving onto a lifting platform or when raising
the vehicle using the jack (car jack mode).
For information on raising the vehicle:
> Please see chapter "Jack and Lifting Platform" on
page 149.
b b Vehicle is stationary.
e CAR
Chassis e Car jack mode
The vehicle can now be raised.
The leveling system switches on automatically at
speeds above approx. 4 mph (7 km/h).
Responding to warning message
PASM faults are displayed on the instrument cluster.
Operation of leveling
system during a wheel
change
e CONTROL
e Vehicle settings e
Information
Advertisement
Table of Contents
