Table of Contents
Advertisement
Roof transport system
A
1. Unlock the covers counter-clockwise using the
key.
B
C
D
E
F
G
H
I
J
K
L
M
Fig. 169: Unlocking the cover
N
2. Pull the covers upward in two steps until they
O
engage.
P
Make sure that the cover is not subjected to any
load.
Q
R
S
T
U
V
W
X
Y
Z
242
Fig. 170: Folding up the cover
3. Pull out the fastening screws and turn counter-
clockwise to the stop.
Fig. 171: Remove the fastening screw and turn counter-
clockwise.
4. Identify the front and rear carrier bars based on
the sticker and carefully place them onto the roof
rails.
Ensure that the sticker is located on the left in
the direction of travel.
5. Only fit the locking pin for the carrier bars A at
the marked areas of the bore B.
Fig. 172: Placing the carrier on the roof
6. Check that the carrier bars are correctly seated
on the roof rail.
7. Tighten the fastening screws slightly clockwise,
in a diagonally opposite sequence, but do not yet
tighten completely.
Make sure that the locking pins and carrier bars
are still secure and cannot slip.
8. Tighten the fastening screws clockwise, in a di-
agonally opposite sequence, until they audibly
click and then press them in.
9. Close the covers and lock them clockwise using
the key.
Advertisement
Table of Contents
