Table of Contents
Advertisement
Roof transport system
A
B
C
D
E
F
G
Fig. 177: Swivel the fastening bracket upward and engage it
H
in the carrier support
I
5. Swivel the fastening bracket upward and engage
it in the carrier support.
J
6. Open the vehicle door.
K
L
M
N
O
P
Q
R
S
T
U
V
Fig. 178: Placing the carrier on the roof
W
7. Place the carrier on the roof carefully so that the
X
position mark is on the correct side of the
vehicle.
Y
FL Front Left / FR Front Right / RL Rear Left /
Z
RR Rear Right.
244
Fig. 179: Detach the fastening bracket and insert the lock-
ing pin
8. Disengage the angle bracket and insert the
locking pin in the relevant bore on the inside of
the roof frame.
9. Push the fastening bracket upwards. If the fas-
tening bracket cannot be pushed upwards with-
out exerting force, realign the carrier.
10.Tighten the fastening screws in the support feet
on both carriers slightly, but do not yet tighten
them fully. Make sure that the locking pins are
still secure and the carriers cannot slip.
11.Tighten the fastening screws alternately to a
torque of approx. 2.6–3.3 lb-ft (3.5–4.5 Nm)
clockwise using the torque wrench.
12.Close the covers and turn the key clockwise.
Then, insert cover trims if necessary.
Information
e Re-tighten the fastenings after a short journey
and check them again at regular intervals.
e The screw connections must be checked more
frequently on bad roads. Loosening or loss of
mounting components can result in serious
accidents.
Fitting accessories
Fig. 180: Cutting the cover trims to size and pressing in
Fig. 181: Fitting accessories (Cayenne Coupé)
b b Covers are opened.
Advertisement
Table of Contents
