Table of Contents
Advertisement
Preparing to Transport a Patient
7.9 - Attachment of other 3rd party
Child harness (cont...)
To attach the ACR lower fixing straps, use the dedicated fixing stud
positioned at each side of the trolley at the base of the backrest.
Place the tang over the fixing stud such that the stud is protruding
through the tang and then pull the strap until the tang clicks in
place.
Attachment of lower ACR fixing straps to fixing stud at
base of backrest either side of the trolley
Once all the attachment straps are firmly and correctly attached
to the trolley, tighten each strap, ensuring that the ACR is in the
correct position, central to the trolley, and tightly attached such
that it does not move.
After the ACR has been used, disconnect the tangs from each
attachment point on the trolley. Note that the tangs can be kept
connected to the ACR fixing straps whilst the harness is not in use
and being stored.
32
7 - PREPARING TO TRANSPORT A PATIENT
7.10 - Strap Attachment Points (Cross-
Strap Harness)
A summary of the various attachment points on CCT-PX with
Cross-strap harness is as per below list:
1. Attachment point for ACR lower fixing straps
2. Attachment point for buckle for crossover strap
3. Attachment point for bottom end of crossover strap. End of
Crossover strap also incorporates loop for attaching Pedimate.
4. Not used
5. Attachment point for lower-leg strap
7.11 - Using BabyPod on CCT-PX
Please refer to the BabyPod user manual for the procedure for
attaching and using BabyPod on a trolley.
CCT-PX can be used to transport BabyPod unit. Attachment of
BabyPod to CCT-PX is the same procedure as any other trolley,
where the 2 fixing straps are fed around and under the belly of
the trolley and then re-attached to the buckles on the opposite
side of the BabyPod. The BabyPod foot-end fixing strap should be
attached to the trolley foot-end red cross-handle.
BabyPod strapped to trolley top
FERNO/MAN/1121/226-R3/UK
Advertisement
Table of Contents
