Table of Contents
Advertisement
5.25 - Attaching Split-Scoop Fixing Kit
(cont....)
Lock the bracket in place by pressing down on the red
locking handle until it clicks
Repeat the process at the head-end of the trolley with one of
the shorter fixing brackets with a 'head' label, then repeat the
process both foot-end and head-end on the other side of the
trolley such that all 4 brackets are firmly attached.
Next, make sure that the Scoop length has been extended and
locked in to the first extension position.
Then split the Scoop EXL into 2 halves by opening the TSL locks
at both the head-end and foot-end of the Scoop.
Lay each of the 2 halves of the Scoop over the fixing brackets
attached to the trolley.
Note the orientation of the Scoop should be such that foot-end
of the Scoop is at the head-end of the trolley and the head-end
of the Scoop at the foot-end of the trolley, as per the below
picture. This ensures maximum usable extended patient surface.
Two halves of Scoop laid on top of fixing brackets
24
6 - OPERATING THE TROLLEY
5.25 - Attaching Split-Scoop Fixing Kit
(cont...)
The Split-Scoop half-sections should be positioned along the
length of the trolley such that the lift-up locking arms on the
brackets correctly line up with the hand-hold holes in the sides
of the Scoop as shown below.
Fixing bracket lift-up locking arm
Ensure Scoop hand-hold holes line up with locking
arms on fixing brackets at foot-end as per photo
above
Ensure that the fins of the Scoop are correctly held into the
fin holders on each of the fixing brackets at the head-end and
foot-end and that the locking arms are still sat correctly in the
hand-hold holes of the Scoop.
Ensure Scoop fins are under the holding plates
Operating the Trolley
FERNO/MAN/1121/226-R3/UK
Advertisement
Table of Contents
