Table of Contents
Advertisement
UNI-ClipDoc
5.4
Installation using clamp
fixing-bars (cont....
Once the cross bars are in the correct configuration, they
can be attached to the Uni-ClipDoc in the appropriate
positions for the trolley being used (see section 5.3).
To unlock the clamps, lift the sliding lock plates up as
pictured below. Offer the Uni-Clip doc up to the trolley
and position centrally across the length and width.
Push down on the Uni-ClipDoc to locate the clamps on the
side rail of the trolley.
Close all four clamps, push down on the sliding lock plates
until they click into the locked position.
The Uni-ClipDoc is now ready for use.
5.5
Installation using the ratcheting fixing-bars
With the ratcheting fixing-bars installed in the appropriate positions, offer the UNI-ClipDoc up to
the trolley and position it centrally across the length and width of the trolley top.
FIG 1
Unlock the ratchet mechanism by lifting the lever marked "Release" and rotate the ratchet lever
down fully.
FIG 3
Pull on the tang- end of the strap to release tension from the ratchet and provide enough slack to
allow feeding of the strap around the trolley siderail.
Feed the end of the strap with the tang attached around the back of the trolley side rail,
underneath and then back up the front of the siderail.
12
5.0 - OPERATION
FIG 2
FIG 4
FERNO/MAN/0721/220-R2/UK
Advertisement
Table of Contents
