Table of Contents
Advertisement
4.12 - 3 stage IV Pole (Option)
The 3-stage IV pole attaches to the side-rail of the trolley and is
telescopic in 3 stages, allowing it to be positioned and raised/
lowered according to the needs and situation of the patient
being transported.
Clip the IV pole under the siderail interface from behind, angling
the IV pole slightly away from you, then bringing it forward
again, hold it in place and pushing down on the red handle. The
IV pole will lock into place.
With the IV pole folded for storage, whilst travelling in a vehicle
the Velcro strip should be used to attach the end of the IV pole to
the trolley side to avoid it lifting up out of place.
Attaching the IV pole to trolley side rail
4.13 - Adjusting the Height of IV Pole
Using the red clamp levers located on each of the IV pole sections,
starting from the bottom un-clamp and extend each of the
telescoping poles until the correct height is achieved, ensuring
that each clamp lever is firmly closed again once the IV pole has
been adjusted to the required height.
Adjusting the height of IV pole
For more information on the 3-stage IV Pole
please also refer to the 3-stage IV pole User
Manual, reference 00271-AU-V01, which is
available from Ferno.
FERNO/MAN/1121/226-R3/UK
4 - CCT-PX TROLLEY FEATURES
4.14 - Balloon Pump fixed platform
(Option)
The optional BP fixed platform allows Balloon Pump unit to be
stored on the CCT-PX trolley.
The unit is attached to the platform using the supplied straps,
one to wrap around the unit and 2 which go up and over the unit
to hold it in place on the platform.
CCT-PX Features
11
Advertisement
Table of Contents
