Table of Contents
Advertisement
Operating the Trolley
5.25 - Attaching Split-Scoop Fixing Kit
(cont...)
Continue to twist the lever until the top of the locking device is
holding hard against the body of the Scoop and the lever fully
up.
Locking device holding against the Scoop body
Repeat this for all 4 fixing brackets, ensuring that each is fully
locked in place, visibly checking the position of the levers
underneath, which should be fully up. At the head-end of the
trolley the locking arms should be holding the outer edge of
the Scoop. Double-check that all brackets are indeed locked by
trying to lift or move the Scoop up by hand. The Scoop should
remain in place.
Locking device lever in full up position, locked
IMPORTANT BEFORE USING: Re-check all 4 locking levers on
the fixing brackets to make sure they are fully down and that the
fixing arms are securely locked to the trolley siderail interface.
Recheck the Scoop to ensure it is firmly locked in place.
Raise and lower the trolley to ensure there is no contact with the
Scoop or obstruction hindering movement.
Check backrest and leg platform movement to ensure there is no
infringement by the Scoop. If there is, move and/or extend the
Scoop so that it no longer interferes.
Note that when using the Split-Scoop module the Scoop sides
MUST be supported underneath when moving a patient on/off
the trolley to ensure there is no imbalance of trolley and should
always be carried out with the trolley in the lowest possible
position.
26
6 - OPERATING THE TROLLEY
FERNO/MAN/1121/226-R3/UK
Advertisement
Table of Contents
