Servicing & Repl Acing Comp Onent S; Re Versing Door - True TUI-15-R-SS-D Install Manual And User Manual

S E R V I C I N G , R E P L A C I N G C O M P O N E N T S & A D J U S T M E N T S
SERVICING & REPL ACING
COMP ONENT S
NO T E: A N Y C A BINE T A D JU S T MEN T S A R E T O
BE M A D E A F T ER T HE C A BINE T H A S BEEN
V ER IF IED L E V EL A ND P R OP ER LY SUP P O R T ED.
• Replace component parts with original equipment
manufacturer (OEM) components.
• Contact the dealer or our parts department at
844-849-6179 TrueResidentialParts@truemfg.com
or
for replacement parts.
• Have a licensed service provider service your unit
to minimize the risk of possible ignition due to
incorrect parts or improper service and to ensure
the operator's health and safety.
• Unplug the ice machine before cleaning or making
any repairs. Powering off an electronic control may
not remove power from all components
(e.g., light circuits, perimeter heaters, and
evaporator fans).

RE VERSING DOOR

The new TUI-15 models come with articulating, soft-
close hinges. The hinges can be installed on either the
left-hand or right-hand orientation.
To order additional spacers of NSF cover screw caps,
contact our parts department at
TrueResidentialParts@TrueMfg.com.
R EQUIR ED T O O L S
Required tools include (but may not be limited to) the
following:
• 1/8" Hex Head Allen Wrench
• Putty Knife (if NSF cover present)
Page 56 of 64 T RUE RE S ID E N TI A L
844-89-6226 or
12/07/2021
®
P R O CEDUR E
NOTE: Figures show converting a right-hinged door to a
left-hinged door.
1. Loosen the hinge bolts and remove the door.
See fig. 1.
2. If NSF Cover is present, carefully pry screw caps
from the cover to access the door bracket screws.
See fig. 2.
3. If present, remove the door skin. See fig. 3.
4. Remove the existing spacer. See fig. 3.
5. Remove the hinge assemblies from the door
assembly. See fig. 4.
6. Shift the door brackets to the opposite side.
See fig. 5.
7. Install the bottom hinge at the top and the top
hinge on the bottom. See figs. 6 and 7.
8. Install the door skin. If present, reinstall the NSF
cover screw caps.
9. Move the remaining door hardware to the opposite
sides. See fig. 8.
10. Install the reversed door. Be sure to fully tighten
the hinge screws.
NO T E: BE SUR E T O IN S TA L L T HE C O R R EC T
SPA CER F O R YOUR D O O R O R IEN TAT ION.
11. Verify the door closes correctly and the gasket
seals without gaps. Adjust the door as needed. See
"Door Adjustment" (page 59).
TEC_TM_155 REV. A