True TUI-15-R-SS-D Install Manual And User Manual page 50

S A NI T I Z ING
1. Remove the ice guide, water supply, spray bar and
pump clean-out cap. See "Interior Components"
(page 51).
2. Mix 1.5 fluid ounces (3 tbsp) of 5.25%
hypochlorite solution (chlorine bleach) with 3
gallons of warm water.
3. Use 1/2 of the solution to sanitize the removed
parts. Soak the parts in the solution.
THE PARTS AFTER SANITIZING.
4. With the remaining solution, sanitize the interior
surfaces of the machine and the bin.
RINSE THE SANITIZED AREAS.
5. Reinstall the components.
CLEAN
6. Press and hold
will show dES.
7. Press LIGHT and / or
either SAn (descale only) or
sanitize).
Run Sanitize
cycle only
8. With the display showing the desired cycle, press
the TRUE logo. The display will show Str.
9. Press LIGHT and / or
shows either Str (startup) or
This determines the ice machine's action upon
completion of the selected cleaning cycle.
Machine will begin
ice making sequence
10. With the display showing the desired action,
press the TRUE logo. The selected cleaning cycle
will begin.
Page 50 of 64 T RUE RE S ID E N TI A L
M A I N T E N A N C E , C A R E & C L E A N I N G
DO NOT RINSE
DO NOT
for 3 seconds. The display
CLEAN until the display shows
bth (both descale and
Run both descale
and sanitize cycles
CLEAN until the display
Stb (standby).
Machine will
enter standby
®
11. The display will alternate between
(preclean) for approximately 3 minutes.
Preclean stage
12. When the display shows Add, pour 2 teaspoons of
5.25% hypochlorite solution (chlorine bleach) into
the spray compartment behind the water shutters.
13. After adding the sanitizer solution, press the TRUE
logo. The automatic cycle will continue.
While running the
automatic clean cycle
14. Wait for the sanitizing cycle to finish. Immediately
rinse off and dry any exterior areas where
sanitizing solution may have spilled.
12/07/2021
PrE and
Add cleaning
chemicals
TEC_TM_155 REV. A
CLn