El Ectrical Instal L Ation & S Afe T Y - True TUI-15-R-SS-D Install Manual And User Manual

ELEC TRIC AL INS TALL ATION & SAFE T Y
The unit is approved by UL for outdoor installation.
U SE O F A DA P T ER P L UG S
NEVER USE AN ADAPTER PLUG!
original OEM plug configuration when
connecting it to a power source.
TRUE will not warranty any refrigerator/
freezer that has been connected to an
adapter plug.
U SE O F E X T EN SION C O R D S
NEVER USE AN EXTENSION CORD!
determined to be any component that adds length to
the original OEM power cord when connecting it to a
power source.
TRUE will not warranty any refrigerator/
freezer that has been connected to an
extension cord.
HO W T O C ONNEC T EL EC T R ICI T Y
• The ice maker should always be
plugged into a dedicated electrical circuit. This
provides the best performance and prevents
building wiring circuits from being overloaded, which
could cause
a fire hazard from overheated wires.
• Before your new unit is connected to a power
supply, check the incoming voltage with a voltmeter.
If the recorded voltage is less than the rated voltage
for operation (+/-5%) and amp rating, correct
immediately. Refer to cabinet data plate for this
voltage requirement.
• The electrical outlet must be within 36" (914.4 mm)
of the center of the back wall of the ice maker's final
location. Outlet must be flush with wall and comply
with local electrical codes.
• The wall outlet and circuit should be checked by
a licensed electrician to make sure the outlet is
properly grounded.
Page 22 of 64 T RUE RE S ID E N TI A L
P R I O R T O I N S T A L L A T I O N
An adapter plug alters the
An extension cord is
®
• The power cord of this appliance is equipped
with a 3-prong (grounding) plug which mates
with a standard 3-prong (grounding) wall outlet to
minimize the possibility of electric shock hazard
from this appliance. A 115V AC, 60 Hz, 15 amp
circuit breaker and electrical supply are required.
• If the outlet is a standard 2-prong outlet, it is your
personal responsibility and obligation to have it
replaced with the properly grounded wall outlet.
• DO NOT, under any circumstances, cut or remove the
ground prong from the power cord. For personal
safety, this appliance must be properly grounded.
• When moving the ice maker, for any reason, be
careful not to roll over or damage the power cord.
• Repair or replace immediately all power cords that
have become frayed or otherwise damaged.
use a power cord that shows cracks or abrasion
damage along its length or at either end.
• If the supply power cord is damaged, it should be
replaced with original equipment manufacturer
(OEM) components. To avoid hazard this should be
done by a licensed service provider.
• NEVER
unplug your ice maker by pulling on the
power cord. Always grip plug firmly and pull straight
out from the outlet.
12/07/2021
DO NOT
TEC_TM_155 REV. A