Pre-Installation And Application Warnings - Directed DIRECTECHS DB3 Installation Manual

Pre-installation and application warnings

Firmware notes: This section highlights important information for this specific firmware and will assist in pricing
accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
Š Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.
Š Refer to the "Vehicle connections" following the installation diagram.
General notes: This section highlights important information for this specific firmware.
Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D. Also please note that by
[1]
default, the tach is set to 1000 rpm on hybrid vehicles.
The installation of an aftermarket hood pin is ONLY required on vehicles that are NOT equipped with a factory hood pin. or if NOT
[2]
supported in data.
5
403.MIT5 1.06 2018 Mitsubishi RVR (Smart Key)
©2021 VOXX•DEI LLC. All rights reserved.
Keys
Keys required
1
required for
for operation
programming
0