Camera Interfaces - Quectel SC606T Series Hardware Design

TP1_I2C_SCL
TP1_I2C_SDA
A reference design for touch panel interfaces is shown below.
TP_I2C_SDA
TP_I2C_SCL
TP_RST
TP_INT
Module
NOTE
By default, TP is powered by LDO10_2P8, which outputs a current of 150 mA. When dual-TP or other
applications need to be supported, it is recommended to use an external LDO instead.

3.18. Camera Interfaces

Based on standard MIPI_CSI input interface, The module supports 3 cameras (4-lane + 4-lane + 4-lane)
or 4 cameras (4-lane + 4-lane + 2-lane + 1-lane). The video and photo quality is determined by various
factors such as the quality of camera sensor and camera lens.
Table 21: Pin Definition of Camera Interfaces
Pin Name Pin No.
LDO2_1P1 13
SC606T_Series_Hardware_Design
205 OD TP1 I2C clock
204 OD TP1 I2C data
LDO6_1P8
R1 R2
2.2K 2.2K
D1 D2
Figure 21: Reference Design for Touch Panel Interface
I/O Description
1.1 V output power for DVDD of rear
PO
Camera
SC606T Series Hardware Design
LDO10_2P8
D4
D3
C1 C2
4.7 μ F 100 nF
Smart Module Series
1.8 V power domain.
1.8 V power domain.
1
SDA 1.8V
2
SCL 1.8V
3
RESET 1.8V
4
INT 1.8V
5
GND
6
VDD 2.8V
D5
TP
Comment
Vnom = 1.1 V
I max = 1200 mA
O
59 / 116