Residual Risk Assessment - PRONAR PT512 Operator's Manual

CHAPTER 2
• If the trailer must be raised, use only proper and approved hydraulic or
mechanical jacks for this purpose. After lifting the machine, use stable and
durable supports. Works must not be carried out under a trailer which has only
been raised by a jack.
• The trailer must not be supported by means of brittle objects (bricks or concrete
blocks).
• After completing works associated with lubrication, remove excess oil or grease.
The trailer should be kept clean and tidy.
• Exercise caution when climbing on top of the loading case. Climbing on the top of
the loading case is possible by use of ladders located on the front wall, extension
and the draw bar, as well as by means of foldable steps inside the loading case.
Components not intended to aid access may not be used for this purpose. Before
entering the loading case, prevent trailer moving with the parking brake and
chocks.
• Do not make independent repairs of control valve, brake cylinders, tipping
cylinder and braking force regulator. In the event of damage to these
components, replace them or have them repaired by an authorized servicing
center.
• Do not repair the drawbar and its eye (straightening, repairing or welding).
A damaged drawbar must be replaced.
• Do not install additional devices or equipment not conforming to manufacturer's
requirements.
• The trailer can only be towed if its traction, lighting and braking systems are
operating normally.

2.2 RESIDUAL RISK ASSESSMENT

Pronar Sp. z o. o. with its premises in Narew has made every effort to eliminate the risk of
accidents. There is however certain residual risk which could lead to an accident; this is
connected mainly with the actions described below:
• using the trailer for purposes other than those for which it is intended,
2.13
Pronar PT512