Table of Contents
Advertisement
2. Device Control Panel (Lower)
(1) Remove the device control panel (top) assembly, then
disconnect the flat cable from the connector (CN400)
on the CPU-314 board. (Refer to steps (1) and (2) in
section 2-5-2-1.)
(2) Remove three screws (PSW3 x 8 : 2 pieces,
BVTP3 x 8 : 1 piece) and remove the shield plate
(upper).
(3) Remove five screws (BVTP 3 x 8 : 4 pieces, PSW 3 x 6
: 1 piece), then remove the CPU-314 board, shield
plate (lower) and reinforcement.
(4) Remove two screws (B3 x 6) and remove the rear
panel.
BVTP3 x 8
Reinforcement
BVTP3 x 8
CPU-314
board
Shield plate (lower)
Shield plate (lower)
n
When disconnecting/re-connecting the flat cable, be
careful not to damage it.
DMW-S01NL/S02NL/ST001
http://getMANUAL.com
PSW3 x 8
(4-382-854-01)
Shield plate (upper)
BVTP3 x 8
PSW3 x 6
Rear panel
B3 x 6
Device control
panel (lower)
2-5-3. Replacement of Main Parts
1. Replacement of electromagnetic clutch
assembly
Required tool
L-shaped hex.wrench
(Width across flat = 3 mm) : 7-721-140-60
(1) Remove five screws (BVTP3 x 8) and remove the
device control panel (upper) assembly. (Refer to
section 2-5-2.)
(2) Disconnect the harness from the connector (CN1) on
the DET-11 board.
(3) Remove three screws (BVTP3 x 8) and remove the
search dial assembly.
BVTP3 x 8
Search dial
assembly
Device control panel (top) assembly
2-5. Jog & Shuttle Control Panel
DET-11 board
CN1
Harness
2-31
Advertisement
Table of Contents
