Table of Contents
Advertisement
2-2. Audio Control Panel
2-2-2. Removing of Cabinet
1. Fader Panel assembly
(1) Remove nine fader keys and a encoder knob.
(2) Remove six screws (BVTP3 x 8) and remove the fader
panel (upper) assembly from the fader panel (lower).
n
When remove the fader panel (upper) assembly, be
careful not stretch it because the cables are connected
to the boards inside fader panel (lower).
(3) Disconnect one harness and two flat cables from the
connectors (CN403, CN404, CN405) on the CPU-315
board.
Draw out the flat cables from the ferrite cores.
Fader keys
Harness
CN405
CPU-315
board
BVTP3 x 8
Ferrite cores
CN404
CN403
2-20
(4) Remove the screw (PSW3 x 8) and remove the shield
(5) Remove five screws (BVTP3 x 8) and remove the
(6) Remove three screws (BVTP3 x 8) and remove the
(7) Remove two screws (BVTP3 x 8) and remove the
(8) Remove six screws (BVTP3 x 8) and remove the
Encoder knob
Fader panel
(upper)
assembly
Shield core
bracket (A)
Flat
cables
Fader
panel
(lower)
assembly
n
When disconnecting / re-connecting the flat cable, be
careful not damage it.
sheet.
KY-471 board. Disconnect the flat cable from the
connector (CN100) on the KY-471 board.
KY-472 board. Disconnect the flat cable from the
connector (CN200) on the KY-472 board.
CN-2002 board. Disconnect the flat cable from the
connector (CN300) on the CN-2002 board.
spring (B) and SV-220 board assembly.
PSW3 x 8
Shield sheet
BVTP3 x 8
CN-2002 board
CN300
Flat cables
BVTP3 x 8
Ferrite
core
CN100
CN100
CN100
BVTP3 x 8
BVTP3 x 8
BVTP3
KY-472
CN200
CN200
CN200
board
Shield core bracket (B)
Ferrite core
Flat cable
BVTP3 x 8
KY-471
board
BVTP3 x 8
BVTP3 x 8
BVTP3
BVTP3 x 8
BVTP3 x 8
BVTP3
Spring (B)
SV-220
board
assembly
Fader panel assembly
DMW-S01NL/S02NL/ST001
Advertisement
Table of Contents
