Table of Contents
Advertisement
2-1. Digital media workstation/A/V block
f) CN-2080 Board
(1) Remove the AV I/O block. (Refer to "Sec. 2-1-2".)
(2) Disconnect the one cable.
(3) Remove the four connector screws and remove the
CN-2080 board.
. Service tool required
Box driver (Width across flat : 5 mm)
... Part No. : 7-721-052-05
Connector screws
m
. After replacing the CN-2080 board, perform the opera-
tion check and adjustment, and then perform the reas-
sembling of each parts.
. When wiring the cable, fasten it with wire holder on the
CN-2080 board to have no loosing.
2-18
CN-2080 board
CN103
Cable
g) Coaxial cable
(1) Remove the AV I/O block. (Refer to "Sec. 2-1-2".)
(2) Disconnect the one coaxial cable.
(3) Remove the one nut and one washer, remove the
coaxial connector.
Washer
Coaxial connectors
n
When reconnecting the coaxial cable, be sure to insert
strongly.
Coaxial cable connections
Panel indication
MPU-120 board
SDI IN
CN2001, SDI IN
SDI OUT
CN3001, PGM OUT
SYSTEM I/F IN
CN2701, FROM PC
SYSTEM I/F OUT
CN2601, TO PC
MON OUT
CN3201, MON OUT 1
Panel indication
MTS-11 board
REF OUT2
CN5401, BB_OUT2
Coaxial cable
Nut
Color
Black
Red
Orange
Yellow
Green
Color
Black
DMW-S01NL/S02NL/ST001
Advertisement
Table of Contents
