Table of Contents
Advertisement
2-1. Digital media workstation/A/V block
(8) Disconnect the three power supply cables and one
signal cable.
(9) Remove the five screws (PWH3 x 5) and remove the
AH-65 board.
CN505
CN1
AH-65 board
Signal cable
n
After replacing the AH-65 board, be sure to perform the
operation check, then reassembling of each parts.
Adjustment after replacement of the AH-65 board
After replacing the AH-65 board, confirm the output
voltage of the DC-DC converter is correct.
(Refer to "Sec. 7-2".)
2-14
CN506
CN501
PWH3 x 5
Power cable
b) MPU-120 Board
(1) Remove the AV I/O block. (Refer to "Sec. 2-1-2".)
(2) Remove the four screws (PWH3 x 5) and remove the
PCI duct.
(3) Disconnect the USB cable.
PWH3 x 5
USB cable
PCI duct
PWH3 x 5
DMW-S01NL/S02NL/ST001
Advertisement
Table of Contents
