Table of Contents
Advertisement
2-1. Digital media workstation/A/V block
(5) Remove the two screws (PSW4 x 8) and remove the
fan assembly.
1 DMW-S01NL Serial No. 30001 to 30015 (for J)
Serial No. 10001 to 10050 (for SY)
PSW4 x 8
Fan Assy
MB Support
2 DMW-S01NL Serial No. 30016 (for J) and higher
Serial No. 10051 (for SY) and higher
DMW-S02NL Serial No. 30001 (for J) and higher
Serial No. 10001 (for SY) and higher
Fan Assy
MB Support
(6) Disconnect the three cables from power supply
connectors on the mother board.
2-4
PSW4 x 8
Fan Assy
Fan No. label
Mother board
(7) Remove the two screws (BVTP5 x 10) of each three
finger guards and remove them.
(8) Remove the two screws (BVTP5 x 10) of each three
fans and remove them.
BVTP5 x 10
n
When removing the fan assembly, be careful not to pull the
connecting cable as well as not to damage it.
Adjustment after replacement of the cabinet fan
After replacing the fan, perform the operation check using
the BIOS setting menu (Refer to "Sec. 5-1").
n
After replacing the fan, be sure to perform the operation
check, then perform the reassembling of each parts.
Assembly after replacement of the fan
. After replacing the fan, attach the provided fan No. label
to the cable.
Because servicing fan has the three labels, be sure to
attach the same No. label as the replaced fan No. label.
. When installing the Fan assembly, make sure that attach
it firmly with groove of the MB support (Bracket for
Mother board installation).
BVTP5 x 10
Finger guard
Fan
DMW-S01NL/S02NL/ST001
Advertisement
Table of Contents
