Table of Contents
Advertisement
(3) Select the icons of the HDD to use from the tree
structure.
For SDTV system
Select six or more HDD for video data and one or
more hard disk drive for audio data.
For HDTV system
Select six or more HDD for video data per Fibre
channel port (at least 12 drives in total) and one or
more hard disk drive for audio data.
(4) Set the "Configuration" parameters.
The following parameters are displayed.
RAID Name
: Enter the name you want to give
to the RAID.
RAID ID
: The ID of the RAID is displayed.
Total Drives
: The total number of HDD is
displayed.
Total Capacity
: The total capacity of all of the
HDD is displayed.
(5) Set the "In-depth Information" parameters as required.
The "In-depth Information" parameters are as follows.
Stripe Size
: Specify the unit size for writing to
the HDD (4 to 1024 KB).
LOG Data Length: Specify the size of the log area
within firmware (0 to 2048
bytes). Specifying 0 sets the
system default value.
(6) Click the "OK" button.
When processing ends, the following dialog appears.
If you want to enable the settings immediately, click
"Reboot Now" button to reboot the Main Unit.
If you want to continue by creating or releasing more
RAID, click the "CLOSE" button to close the dialog.
DMW-S01NL/S02NL/ST001
4. To execute an NTFS format
Use the "Disk Management" tool. To start the "Disk
Management" tool, select "Start" → "Settings" → "Con-
trol Panel" → "Management Tools" → "Computer Man-
agement" , and click the "Disk Management" folder.
(Refer to "Sec. 5-6-5")
5. Releasing RAID
Use the following procedure to release a RAID when it is
no longer needed.
n
Be careful when releasing RAID, because they cannot be
recovered once released.
(1) On the menu bar, select "Disk/RAID (D)" → "Release
RAID (R)".
The Release RAID dialog appears.
1-9. System Initial Setup
1-47
Advertisement
Table of Contents
