Table of Contents
Advertisement
e) HDD
(1) Remove the AV I/O block. (Refer to "Sec. 2-1-2".)
(2) Remove the EMI plate.
(Refer to "Sec. 2-1-3, c) FDD step (2)".)
(3) Remove the front mask(PC). (Refer to "Sec. 2-1-3, 1,
a) Power Module steps (2) to (5)".)
(4) Disconnect the two cables from the HDD.
Power cable
SCSI cable
(5) Remove the four screws (PSW3 x 6) and remove the
HDD assembly by sliding it toward backward.
(6) Remove the four screws (#6-32UNC x 6) and remove
the HDD.
PSW3 x 6
DMW-S01NL/S02NL/ST001
HDD
#6-32UNC x 6
HDD
#6-32UNC x 6
m
. HDD is extreme weak by shock hazard, take care to
handle the HDD to prevent shock.
. Because operating system is only installed with the
HDD, after replacement of the HDD, it is required to
reinstalling of the driver software and utility software.
OS pre-installed HDD part No.
HDD for Japanese OS : 9-885-010-95
HDD for English OS
. After replacing the HDD, be sure to perform the
operation check, then perform the reassembling of each
parts.
Adjustment after replacement of the HDD
. Reinstalls the driver software and utility software and
perform the various setting after replacing the HDD.
(Refer to "Sec.4".)
. After replacing the HDD, perform the operation check
using the utility software "I-Ciser".
(Refer to "Sec. 5-2-1".)
2-1. Digital media workstation/A/V block
: 9-885-010-96
2-7
Advertisement
Table of Contents
