Advanced; Static Route - Billion BiGuard 10 User Manual

Internal IP Address: Enter the LAN server/host IP address that the service request
from the Internet will be sent to.
Candidates: You can also select the Candidates which are referred from the ARP
table for automatic input.
NOTE: You need to give your LAN server/host a static IP address for the Virtual
Server to work properly.
Click Apply to save your changes.
Using port forwarding does have security implications, as outside users will be able
to connect to PCs on your network. For this reason, using specific Virtual Server
entries just for the ports your application requires, instead of using DMZ is
recommended.

4.4.8 Advanced

Configuration options within the Advanced section are for users who wish to take
advantage of the more advanced features of BiGuard 2/10. Users who do not
understand the features should not attempt to reconfigure their router, unless
advised to do so by support staff.
There are five items within the Advanced section: Static Route, Dynamic
DNS ,Device Management, IGMP and VLAN Bridge.
There are three items within the Advanced section: Static Route, Dynamic DNS and
Device Management.

4.4.8.1 Static Route

The static route settings enable the router to route IP packets to another network
109