Advertisement
E T C I n s t a l l a t i o n G u i d e
Aero 24V Occupancy Sensor Interface
Step 5:
N o t e :
Step 6:
Power Up and Test
For detailed programming and configuration information, please reference the Unison
Aero User Programming Guide.
Step 1:
Contains FCC ID: SZV-TCM320U
The enclosed device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(I.) this device may not cause harmful interference and
(ii.) this device must accept any interference received, including
interference that may cause undesired operation.
Contains IC: 5713A-TCM320U
Occ up an cy Sen sor In t er f ace
Refer to the wiring diagram above to connect low voltage 24vDC to the
controller for use with a 24vDC sensor.
a:
Connect the red (+24vDC) wire from the controller to the +24vDC
wire at the sensor.
b:
Connect the black (common) wire from the controller to the
common wire at the sensor.
c:
Connect the yellow (control) wire from the controller to the control
wire at the sensor.
The wired occupancy sensor connection is compatible with all
24vDC sensors. When a sensor is connected, the UAPSO will
function the same as a wireless sensor being linked to a
controller.
Replace the junction box face plate and hardware.
Restore power to the circuit.
Pa ge 4 o f 4
Advertisement
