Measures For Preparation; Unpacking; Storage; Mounting And Start-Up - Samson EB 3963 EN Mounting And Operating Instructions

Measures for preparation

4 Measures for preparation
After receiving the shipment, proceed as
follows:
1. Check the scope of delivery. Compare
the shipment received with the delivery
note.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent
(refer to delivery note).

4.1 Unpacking

NOTICE
!
Risk of solenoid valve damage due to
foreign particles entering the valve.
Î Do not remove the packaging if the
solenoid valve is to be transported to
another location or kept in storage.
Î Do not remove the protective film/
protective caps until immediately before
mounting the device on the valve.
Before mounting the solenoid valve, proceed
as follows:
1. Remove the packaging from the solenoid
valve.
2. Dispose of the packaging in accordance
with the valid regulations.
42

4.2 Storage

NOTICE
!
Risk of solenoid valve damage due to
improper storage.
Î Observe the storage instructions. Contact
SAMSON, if need be.
Storage instructions
− Protect the solenoid valve against
external influences (e.g. impact, shocks,
vibration).
− Do not damage the corrosion protection
(coating).
− Protect the solenoid valve against
moisture and dirt. In damp spaces,
prevent condensation. If necessary, use a
drying agent or heating.
− Observe storage temperature depending
on the permissible ambient temperature
(see technical data in section 3.2).
− Store solenoid valve with closed cover in
airtight packaging.

5 Mounting and start-up

NOTICE
!
Risk of malfunction due to incorrectly per-
formed start-up.
Î Perform start-up following the described
sequence.
EB 3963 EN