Measures for preparation
4 Measures for preparation
After receiving the shipment, proceed as fol-
lows:
1. Check the scope of delivery. Compare
the shipment received with the delivery
note.
2. Check the shipment for transportation
damage. Report any damage to SAM-
SON and the forwarding agent (refer to
delivery note).
4.1 Unpacking
Note
Do not remove the packaging until immedi-
ately before installing the valve into the pipe-
line.
4.2 Transporting and lifting
Due to the low service weight, lifting equip-
ment is not required to lift and transport the
regulator (e.g. to install it into the pipeline).
Transport instructions
− Protect the device against external influ-
ences (e.g. impact).
− Do not damage the corrosion protection
(paint, surface coatings). Repair any
damage immediately.
− Protect the device against moisture and
dirt.
− Observe the permissible ambient tem-
peratures (see Chapter 3.1).
18
4.3 Storage
NOTICE
!
Risk of regulator damage due to improper
storage.
− Observe the storage instructions.
− Avoid long storage times.
− Contact SAMSON in case of different stor-
age conditions or longer storage times.
Note
We recommend to regularly check the device
and the prevailing storage conditions during
long storage periods.
Storage instructions
− Protect the device against external influ-
ences (e.g. impact).
− Do not damage the corrosion protection
(paint, surface coatings). Repair any
damage immediately.
− Protect the device against moisture and
dirt. Store it at a relative humidity of less
than 75 %. In damp spaces, prevent con-
densation. If necessary, use a drying
agent or heating.
− Make sure that the ambient air is free of
acids or other corrosive media.
− Observe the permissible ambient tem-
peratures (see Chapter 3.1).
− Do not place any objects on the device.
EB 2623-1 EN