Table of Contents
Advertisement
4 Measures for preparation
before installation
After receiving the shipment, proceed as fol-
lows:
1. Check the scope of delivery. Compare
the shipment received with the delivery
note.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent
(refer to delivery note).
4.1 Unpacking
NOTICE
!
Risk of regulator damage due to foreign par-
ticles entering the valve.
The protective caps fitted on the regulator's
inlet and outlet prevent foreign particles from
entering the regulator and damaging it.
Do not remove the protective caps until
immediately before installation.
Note
Do not remove the packaging until immedi-
ately before installation.
Proceed as follows to lift and install the regu-
lator:
1. Remove the packaging from the control-
ler.
2. Dispose of the packaging in accordance
with the valid regulations.
EB 2546-1 EN
Measures for preparation before installation
4.2 Transport, lifting and
storage
DANGER
!
Hazard due to suspended loads falling.
Stay clear of suspended or moving loads.
WARNING
!
Risk of lifting equipment tipping and risk of
damage to lifting accessories due to exceed-
ing the rated lifting capacity.
− Only use approved lifting equipment and
accessories whose minimum lifting
capacity is higher than the weight of the
regulator.
− Refer to Table 3 for weights.
WARNING
!
Risk of personal injury due to the regulator
tipping.
− Observe the regulator's center of gravity.
− Secure the regulator against tipping over
or turning.
Note
Personnel must be trained to secure, trans-
port and lift the regulator properly.
17
Advertisement
Table of Contents
