Machine Handle Operation - Numatic NUC244NX Original Instructions Manual

Quick Set-up Guide
A
10
To lower the floor-tool, press down on the left foot pedal lever at the rear of the machine (10-A).
To lower the machine deck to the ground. Stand behind the machine, grip the handles. With your right foot
push the right pedal forward (11-B). (By pushing lever the front support wheel retracts under the deck (11-C)).
Pull the small lever on the right hand side of the handle upwards (12-D) and then pull the handle backwards.
To raise the floor-tool (for over-scrubbing without picking up water) use the toecap locations to the rear of
the floor-tool (E or F).

Machine handle operation

1
Trigger
To start the machine pull one or both triggers in and press the start button with the deck down, this will start the brushes spinning and the battery power
indicator will illuminate to show the power level.
2
With either trigger pulled in press the water on button, this lights up blue to
indicate it is on.
7
www.numatic.com
11
B
Start button
Water On / Off
A
12
B
C
3
Vacuum On / Off
B
Press the vacuum on button, this lights up blue to indicate it is on and the
vacuum starts. You are now ready to start cleaning.
D
E F
Trigger