Quick Set Up Guide; Brush Fitting; Main Tank Assembly Removal - Numatic NUC244NX Original Instructions Manual

!
PLEASE READ BEFORE COMMENCING ANY OPERATION. AFTER THE REMOVAL OF
ALL THE PACKAGING, CAREFULLY OPEN AND CHECK THE CONTENTS.
NUC244NX CONTENTS
● Owner Manual
● Battery Charger & Lead
● Battery Pack
● Scrub Brushes x 2
● Squeegee Assembly
Make sure the handle is locked in upright position
and storage wheels are retracted. Remove the tank
assembly (and battery if fitted) gently lay machine
on its front
Floor tool and vacuum hose fitting
1
Push the floor tool carrier handle down and push the floor tool onto the retaining clips (1 & 2).

Main tank assembly removal

1
Remove the tank assembly from the front of the
machine. Using the inset handle on the front of
the tank assembly (A), lift the tank assembly up
towards the main handle.

Brush fitting -

1
Push the brush / pad holder onto the brush motor
mounts (1 & 2). Note: Gloves are recommended to
be worn whilst fitting and removing the brushes.
2
2
A
Lift and tilt the top of the tank assembly away from the handle as you remove. Place the tank assembly
on a suitable surface in its upright/uppermost position.
Make sure battery is removed before fitting or removing brushes
Quick Set-up Guide
2
To remove the brushes, place your fingers behind
the brush deck in locations shown and gently
wiggle off.
3
A
Take the hose and fit it into the hose retaining clips
then push the open end securely over the centre
fitting on the floor tool. Follow the arrows for the
correct fit. Make sure part (A) of the hose stays
loose and is not over stretched.
www.numatic.com
!
.
3
4