Changing The Floor-Tool Blades; Refitting The Floor-Tool Blades - Numatic NUC244NX Original Instructions Manual

Changing the Floor Tool Blades
!
Always make sure that the machine is switched off and the battery is removed prior to
A
1
Unscrew the two knobs securing the blade
holder (1).
Floor Tool Overview
1. Retaining knobs x 2
2. Front blade (Slotted / Reversible)
3. Blade carrier
4. Rear blade
5. Floor tool main body
NOTE: The blades are designed to be
reversible and rotated giving 4 usable
surfaces (front, back, top and bottom, thus
extending their useful working life).
11
www.numatic.com
any maintenance.
B
2
Remove the blade holder (2).
Refitting the Floor Tool Blades
Refit the blade holder, retain using the two outer knobs. Make sure the slotted
blade goes to the front of the floor-tool.
Refit the floor-tool using the two central knobs to the floor-tool.
Make sure the end holes on both squeegee blades are positioned correctly on
'T' shaped clip mouldings! (A)
5
4
3
2
To change the floor-tool, firstly lower the floor-tool
using the left side floor-tool lowering foot pedal (A).
Pull the floor-tool away from the machine (B).
3
Replace the Squeegee blades using (903531)
replacement blade set (Fig.3), fitting the
blades on to the moulded location lugs.
A
1
!