Battery Fitting & Water Flow Setting - Numatic NUC244NX Original Instructions Manual

Battery fitting and Water flow setting
1
Lift the battery using the battery handle. Place the battery into the battery compartment ensuring it is
securely in place and the orientation is correct (battery handle folds down towards the machine handle (A)).
4
Tilt the bottom of the tank towards the handle
above the battery.
7
A
Located on the left and right side of the machine
are the individual water taps for each brush.
2
5
Line the tank up against the machine handle and
lower the tank down. Make sure it is securely fitted.
8
B
Push the fluid control levers on the Left and Right of the machine to set the desired flow required, this will
vary depending on what brush / pad and floor type the machine is being used on. Note: On first use open
the water taps fully and run the machine for a short period to purge the water flow then adjust taps to
desired flow. Make sure each lever is set to the same position.
Quick Set-up Guide
A
3
Refit the main tank onto the machine.
6
Clean water tank full and fitted to the machine.
9
www.numatic.com
6