Regular Maintenance; Separator Removal & Cleaning; Clean Water Tank Outlet Cleaning - Numatic NUC244NX Original Instructions Manual

Regular Maintenance

Separator removal and cleaning
1
Using thumb and index finger grip the tab of the
separator and pull forwards.
4
Clean water tank outlets
1
A
Make sure the clean water tank is empty. Unscrew
the two clean water outlets, A and B.
9
www.numatic.com
2
Lift the separator away from the tank.
A
2
B
Remove the clean water outlets from the clean
water tank.
3
Take the separator to a suitable cleaning station.
5
Once the separator has been removed, wash thoroughly under a tap
making sure to run water through the tubes and to clean the grid filter (A).
Once clean thoroughly check the rubber seal for any damage or cracks (B).
If any damage or cracks are found on the rubber seal replace the separator.
Failure to replace could cause loss in suction and machine performance.
3
Wash the clean water outlets thoroughly under a
tap, make sure the filter is clean with no blockages.
Check for any damage (if any damage is found
replace the clean water outlets).
B