Machine Operation; Setting The Cleaning Controls - Numatic TVL850/150 Original Instructions Manual

!
ALWAYS ENSURE THAT THE FLOOR IS PRE-SWEPT AND RELEVANT SAFETY SIGNS
Drive the machine to the cleaning site.
Before cleaning operation, place out appropriate warning signs and sweep or dust-mop the floor.
When ready for cleaning lower the floor tool (page 22) and the brush deck (page 43).

Setting the Cleaning Controls

Insert the Ignition key and
switch the machine on.
!
NOTE: MACHINE WILL NOT REVERSE WITH FLOOR TOOL IN LOWERED POSITION
Turn dial to set desired
water flow.
Press the vacuum switch to the
on position to turn on suction.
ARE DISPLAYED.
Set direction switch to forward.
DE - STARKE
VERSCHMUTZUNG
FR - SALISSURES
IMPORTANTES
NL - ZWARE
VERVUILING
PT - SUJIDADE
DIFÍCIL
IT - SPORCO
Lower brush deck by pushing
PESANTE
down on the left pedal, lower
ES - MUCHA handle and raise foot pedal.
SUCIEDAD
PL - CIĘŻKIE
ZABRUDZENIA
SE - KRAFTIG
NEDSMUTSNING
FI - VAIKEAT
TAHRAT
DA - KRAFTIG
TILSMUDSNING

Machine Operation

GB
Turn speed dial to set desired cleaning speed.
The machine is now set up ready to start cleaning, depress the
accelerator pedal to start cleaning process.
Adjust waterflow and speed according to floor type and level of
soiling
47
!
!
Lower floor tool by lifting lever