Quick Set Up Guide; Brush Fitting; Floor Tool And Vacuum Hose Fitting; Main Tank Assembly Removal - Numatic NX300 Instructions Manual

NUC244NX CONTENTS
● Owner Manual
!
● Battery Charger & Lead
● Battery Pack
● Scrub Brushes x 2
● Squeegee Assembly

Brush Fitting

Make sure battery is removed
before fitting or removing brushes.
Make sure the handle is locked in upright
position and storage wheels are retracted.
Remove the tank assembly (and battery if
fitted) gently lay machine on its front

Floor tool and vacuum hose fitting

1
Push the floor tool carrier handle down and push the floor tool onto the retaining clips (1 & 2).
Take the hose and fit it into the hose retaining clips then push the open end securely over the centre fitting on the floor tool. Follow
the arrows for the correct fit. Make sure part (A) of the hose stays loose and is not over stretched.

Main tank assembly removal

1
Remove the tank assembly from the front of
the machine. Using the inset handle on the
front of the tank assembly (A), lift the tank
assembly up towards the main handle.
!
PLEASE READ BEFORE COMMENCING ANY
OPERATION AFTER THE REMOVAL OF ALL THE
PACKAGING, CAREFULLY OPEN AND CHECK THE
1
Push the brush / pad holder onto the
brush motor mounts (1 & 2). Note: Gloves
are recommended to be worn whilst fitting
and removing the brushes.
2
2
A
Lift and tilt the top of the tank assembly away from the handle as you remove. Place
the tank assembly on a suitable surface in its upright/uppermost position.
Quick Set-up Guide
CONTENTS.
2
To remove the brushes, place your fingers
behind the brush deck in locations shown
and gently wiggle off.
3
A
3
5
!
!