Regular Maintenance; Tanks And Filters - Numatic TTB 6055/100T Owner's Instructions Manual

!
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF PRIOR TO ANY

Tanks and Filters

Next remove floor-tool vacuum hose and flush-out with clean-water.
Next empty clean-water tank, using emptying hose and again flush-out
C
with clean-water.
32
Never use the machine without the recommended filter as it may cause damage to the machine.
34
The clean-water tank filter is located to the rear of the battery
compartment, and should be checked at regular intervals.
Unscrew the cap check the filter condition (Fig.35), rinse and refit.
Ensure tank has been emptied and care is taken when working in the
vicinity of batteries.
Any spills should be wiped-up before the top tank is lowered.

Regular Maintenance

MAINTENANCE USING THE MASTER CONTROL ON/OFF KEY.
REMOVE THE KEY PRIOR TO ANY MAINTENANCE OPERATION.
Whilst pressing in the top tank hood toggles, remove the hood (Fig.32)
The hood also has a sealing-rubber which should be examined at every clean-down.
Rinse using clean-water, avoiding the vac filter.
Located in your waste-water (top) tank is a full tank switch, this stops your
machine from working once the waste-water reaches its maximum limit.
Remove vac filter and clean if required (keep dry) (Fig.33).
Remove debris basket filter and rinse using clean-water, and refit.
IMPORTANT If the debris basket is allowed to become clogged, vacuum performance can
deteriorate. (Fig.34)
Note:
After use, empty waste-water tank using emptying
hose and flush-out with clean-water.
A
B
C
B
38
A
33
IMPORTANT
35
!